Skip to content

Broadband challenges finally on the horizon

By Randy Bell

Ward-level meetings planned to determine broadband availability

Four months ago, the City of Clinton was preparing to launch an effort to identify neighborhoods which don’t have high-speed internet service or where the broadband speeds offered aren’t as fast as the internet service providers claim. After a delay at the federal level, the challenge process is being readied once again.

Clintonians will be able to do speed tests and have the results submitted to the Office of Broadband Expansion and Accessibility of Mississippi, so that the entire city can be accurately represented on the map on BEAM’s website showing which addresses have access to satisfactory broadband (served), which have internet service which fails to meet the minimum speeds (underserved), which have no broadband access (unserved) and which neighborhoods are part of an earlier plan to provide broadband (funded). BEAM is getting $1.2 billion to expand high speed service statewide, but only those addresses listed as unserved or underserved will be eligible to receive broadband access from a provider who’s approved for some of that federal funding.

At this point, the map shows most of Clinton as served, with pockets of underserved and unserved on the fringes of the city, and a few others scattered elsewhere.

Director of Communications and Tourism Marlee Price says that may not be a realistic picture of broadband service in the community, however.

“It has come to my attention that a large portion of those who are currently paying for access to the internet are not truly receiving the speeds they are paying for,” says Price.

That’s where the challenge process comes in. Depending on what speed tests show, some of those addresses could be converted from served to underserved and could benefit from a broadband expansion project to receive faster service.

Price says the City will be using a number of platforms, including social media, the City’s website and its newsletter to educate citizens on how to complete a challenge.

“The CMPDD [Central Mississippi Planning and Development District] is partnering with us to assist residents who may be confused by the process and need a little extra assistance.”

Broadband challenges finally on the horizon

Here’s what BEAM says people who believe their broadband service isn’t fast enough should do:

1. Residents can view the service map at https://broadbandms.com/comment/cpf/map.

• “Served” is represented (on the map) by gray dots indicating addresses which are supposed to be receiving 100 Mbps download/20 Mbps upload speeds or faster.

• Red dots are “unserved,” with speeds of 25/3 and below.

• Blue dots are those who are “underserved,” which is above 25/3 but below 100/20.

• “Funded” (green dots) indicate unserved and underserved locations for which funding has already been approved.

 

2. Residents who are represented by a gray dot as served but who do not feel like they are receiving adequate service should enter the resident challenge process, which is expected to kick off in mid-July, tentatively July 18.

 

3. To get ready to challenge, residents must:

· Have access to their service provider bill before entering the challenge,
· Be connected to their home internet service,
· Be as close to their router as possible, and
· Be prepared to conduct three speed tests on three different days. (Email addresses are collected during the initial speed test, and participating residents will receive an email reminder to complete additional testing.)

 

4. Visit BroadBandMS.com, then go to the resident challenge portal.

 

5. During the challenge process, once households have completed three speeds tests on three different days and downloaded the results, the results will need to then be uploaded on the beam.ms.gov website through a link made available during the challenge period.

 

Households can call BEAM at 601-359-5029 or email info@beam.ms.gov with questions or for additional information about the challenge process or any other broadband related issues.

Leave a Comment